1.
A chip out or crack into the _____ area will cause the component to be rejectable
2.
A line around the border of a component
3.
This damage type if greater than 50% of the original metal width is rejectable
4.
What is always needed when picking a die out of a waffle pack with a magnification minimum of 30x
5.
Regardless of wearing these, it is never okay to handle die with your fingers.
6.
When using this type of pack always make sure there is a gap between the cover and the base
7.
Another word for die. The more commonly heard word.
8.
A vacuum chuck is used to remove die from what style gel pack?
9.
Always verify if air bridges are present before using this tool.
10.
When a MMIC has these, it cannot be picked up by a vacuum pen.
11.
Before _____ a waffle pack, gently tap on the top surface
12.
What type of pack does NOT get filler paper?
13.
What position should you open a waffle pack in?
14.
When picking dies from a gel pack you pick from the side of the die using what tool?
15.
How many sheets of white filler paper are used in a waffle pack?
